This article applies to change welding into cleaning.

Process settings

①Cleaning process

Scanning frequency: the swing speed of the motor whose range is 10-100Hz, and it is recommended to set 50.

Scanning width: the scanning width of the light plate whose range is 0-150mm, and it is recommended to set 150.

Duty Cycle: default data is 100%.

Pulse frequency: default data is 2000.

After setting the parameters, if you import and go back, and you can see this process on the left side of the home page.

②Be sure to remove the graduated tube and locking part of the welding gun

③Confirmation of focus

By the scanning of back and forth, near and far, the focus is when the sound is the largest and the spark is the largest. At this time the cleaning should be carried out according to this distance, and in this time the energy is the strongest.

（Generally, the distance from the tip to the plate is about 30 cm and the energy is the strongest)

④The use of gases

It is recommended to use air, and 2-3 kg is enough. If you are going to use other inert gases (argon/nitrogen), be sure the flow rate is more than 20.