Handheld Fiber Laser Welding Machine

The protective lens is burnt

Mar 17, 2022
Performance:

In a short period of time, the protective lens is damaged and there is a burning spot, and the light-emitting surface of the protective lens is dotted with damaged spots, showing black or white black spots


Cause Analysis:

Due to the influence of process/method/setting, etc., the anti-slag causes damage, and very few are abnormal laser light output


Solution

①Appropriately increase the air pressure. Usually, the flow rate is not less than 15, and the pressure is not less than 0.3-0.6Mpa

②When welding, try to weld the welding gun and the plate at 30-70°, not vertical

③Set the parameters as much as possible to slowly rise and fall, such as the on/off delay of 200-500ms, the on/off optical power 20%, and the on/off progressive time 200-300ms, as shown in the figure, you cannot set 0



④When welding aluminum and galvanized sheets, this material will damage the lens more easily than other materials, so the minimum power should be used for welding.

⑤The quality of the protective mirror also determines the durability of its use. It is recommended to use the original lens

⑥At high power, the loss of the lens will increase compared to low power, which is an uncontrollable range

⑦When the above cannot be handled, you can replace the F200 focusing lens + lengthened and wide scale tube to reduce splashes (additional purchase is required)

How Can We Help You?

Learn more about our products and services? Call +8618856420577
Send a message

click here to leave a message

Leave A Message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

Home

Systems

about

contact